HEATIT Z-Water 2, control the hydronic heating 9 outputs

Heatit Z-Water2

Heatit Z-Water2 is a DIN-rail regulator for controlling waterbased heating systems. The module clips right onto a DIN-rail and allows you to control your waterbased heating through your Z-Wave network. Heatit Z-Water2 is equipped with 9 potential free relays for actuators. It also has 2 analog inputs for temperature sensors.

The Heatit Z-Water2 relays may be controlled by associations with other Z-Wave thermostats e.g Heatit. Each relay can control one or several actuators in your underfloor heating system.

Highlights

• Z-Wave
• Regulator for waterbased heating systems
• 9 potential free relays
• Valve exercise
• Can control 230VAC actuators and 24V actuators from an external power supply
• Can be used with Heatit thermostats in each heating zone
• DIN-rail mounting
• SmartStart
• Connector for external antenna
• Firmware update (OTA)
• Supports encryption mode S0, S2 Authenticated Class, S2 Unauthenticated Class
• Can be used with following accessories: Heatit DIN Trafo 24V, Art. no. 54 304 57

TECHNICAL DATA

• Protocol Z-Wave, 868.4MHz
• Chip Z-Wave 800 chip
• Rated voltage 230VAC 50Hz
• Power consumption 0.4W standby
• Ambient temperature 5°C to 40°C
• Storage temperature -30°C to 70°C
• Humidity 10% to 85% RH
• Max. switching current 5A
• Max load per relay 1385VA/150W
• Inputs 10kΩ NTC
• Range RF Min. 40 meters
• Screw terminals Max 2.5mm2 2Nm
• IP Code IP20
• Size (LxHxW) 105 x 58 x 86mm
• Approvals Z-Wave Plus v2, CE
• The device is maintenance-free. Indoor use only.