This miniature SoC (System on Chip) allows to connect any device with a serial interface to a Z-Wave network, and control it wirelessly through the Z-Wave controller.
The serial interface is basically a 5x1 pin connector with the following pins: 3.3V, TXD, RXD, GND, NC. The connection to the Z-Wave antenna is implemented using a reverse pigtail connector.
The module itself contains a Z-Wave 300 chip preloaded with a Z-Wave.Me Z-Wave firmware and a 32K EEPROM. There is an additional 2 x 5 pin programming connector compatible with the 2 x 5 connection of the Sigma Designs standard.
- Z-Wave Serial interface SoC
- Z-Wave compatible
- Extended Z-Wave.Me firmware